本文采用多相流混合模型，针对筒口气体射流环境下水下航形体弹射出筒过程进行仿真研究。通过试验验证了水下垂直非定常多相流场计算方法，初步分析了航形体出筒过程气体分布情况、水动力载荷和表面压力分布规律，对比分析了筒口气体射流降载效果，为航形体具备良好的弹道环境提供技术支撑。
In this paper, mixture multiphase flow mode was used to analyze the whole process of underwater vehicle ejction from the tube with gas jet. The unsteady multiphase flow field calculation method of gas jet forming process underwater vertical launch was established and validated. The gas distribution and the hydrodynamic loads and surface pressure distribution in the process of model underwater vehicle ejection were analyzed, and the effect of gas jet reducing loads was assessed through comparing the results, which can provide technical support for the good trajectory environment of underwater vehicle.
2018,40(5): 132-136 收稿日期：2018-04-10
DOI：10.3404/j.issn.1672-7649.2018.05.025
分类号：358
基金项目：军委科技委国防科技项目基金资助项目（081500）
作者简介：陈飞宇(1987-),男,博士研究生,工程师,主要从事水下发射环境载荷研究
参考文献：
[1] LIU Zhi-yong, YI Shuqun, YAN Kai, et al. Numerical simulation of water-exit cavity[J]. (CAV2003) Osaka, Japan, 2007, (10):1-4.
[2] VAIBHAV K.A, ASHWANI K.J. Jet characteristics from a submerged combustion system[J]. Journal of Applied Energy, 2012, 89(1):246-253.
[3] LOU Jing, LI Jian. Two dimensional simulation of the collapse of vapor bubbles near a wall[J]. Journal of Fluid Engineering, 2008, 130:091-301.
[4] 尚书聪, 孙建中, 程栋. 筒口气幕环境下的航形体出筒姿态数值仿真[J]. 应用力学学报, 2013, 428-433.
[5] 尚书聪, 孙建中, 程栋, 等. 筒口气幕环境的航形体出筒过程受力影响[J]. 哈尔滨工程大学学报, 2012, 1423-1434.
[6] 甘晓松, 贾有军, 鲁传敬. 水下燃气射流流场数值研究[J]. 固体火箭技术, 2009, 23-26.
[7] 许佳伟. 不同深度下航形体水下点火燃气射流流场数值模拟[D]. 哈尔滨:哈尔滨工业大学, 2011.
