本文以一种装载在液货船上的小型旋流燃烧器为对象，利用Fluent商用软件，采用非预混PDF燃烧模型、DPM离散相模型和D0辐射模型等，对其内部冷热态流场进行数值模拟研究，得到了燃烧器内部燃油喷射、油气混合以及燃烧流动的规律，模拟结果和试验数据基本吻合。通过分析燃烧室内部压力场、速度场、温度场、组分浓度场的变化，找到燃烧室内部烟气流动的规律，仿真结果对实际运行、设计及改造提供了有益的参考意见。
In this paper, a small swirl burner mounted on a tanker is used, and the internal cold and hot flow field is carried out by using Fluent commercial software, non-premixed PDF combustion model, DPM discrete phase model and D0 radiation model. Numerical simulation studies have obtained the law of fuel injection, oil and gas mixing and combustion flow inside the burner. The simulation results are basically consistent with the experimental data. By analyzing the changes of pressure field, velocity field, temperature field and component concentration field inside the combustion chamber, the law of flue gas flow inside the combustion chamber is found. The simulation results provide useful reference for actual operation, design and transformation.
2020,42(4): 70-74 收稿日期：2019-01-15
DOI：10.3404/j.issn.1672-7649.2020.04.014
分类号：TK229.7
作者简介：陈宁(1968-)，男，教授，主要研究方向为船舶及轮机系统的数字化设计与制造技术
参考文献：
[1] 闫伟. 成品油轮惰气发生器(IGG)系统原理及管理建议[J]. 科技信息, 2011(7): 80+426
YAN Wei. Principles and management suggestions of product oil tank inertia generator (IGG) system[J]. Science and Technology Information, 2011(7): 80+426
[2] 杨博雯. WNS燃油锅炉水处理质量评价及其燃烧的数值模拟[D]. 西安: 西北大学, 2016.
YANG Bowen. Water quality evaluation of WNS oil-fired boiler and numerical simulation of combustion[D]. Xi'an: Xi'an: Northwest University, 2016.
[3] 邱冰冰, 杨步云, 李文科. 配风比对燃油燃烧器燃烧过程影响的数值模拟[J]. 安徽工业大学学报(自科版), 2001, 26(1): 5–8
QIU Bingbing, YANG Buyun, LI Wenke. Numerical simulation of influence of air distribution ratio on combustion process of oil burner[J]. Journal of Anhui University of Technology, 2001, 26(1): 5–8
[4] 陈朝晖, 程勇, 王远成. 旋流燃烧室内冷态和热态流场的三维数值模拟分析[J]. 化工机械, 2007, 34(1): 12–18
CHEN Zhaohui, CHENG Yong, WANG Yuancheng. Three-dimensional numerical simulation analysis of cold and hot flow fields in a swirling combustion chamber[J]. Chemical Industry, 2007, 34(1): 12–18
[5] 温正, 石良臣, 任毅如. FLUENT流体计算应用教程[M]. 清华大学出版社, 2009.
[6] 姚寿广, 付德钢, 马哲树. 旋流器进风宽度对文丘里调风器出口流场的影响[J]. 燃烧科学与技术, 2003, 9(1): 93–95
YAO Shouguang, FU Degang, MA Zheshu. Influence of vortex inlet width on the flow field of Venturi ventilator outlet[J]. Journal of Combustion Science and Technology, 2003, 9(1): 93–95
[7] 许春伟. Omega型烟气流程的燃油锅炉内燃烧与传热研究[D]. 大连: 大连理工大学, 2015.
XU Chunwei. Study on combustion and heat transfer in oil-fired boilers of Omega-type flue gas process[D]. Dalian: Dalian University of Technology, 2015.
[8] 温正, 石良臣, 任毅如. FLUENT流体计算应用教程[M]. 清华大学出版社, 2009.
